6/3/2023 0 Comments E3d hemera dimensions> Please note this is generally the most used printer convention, exceptions are applicable. When facing your printer the left to right movement is your X-axis, back and forth the Y-axis and up and down the Z-axis. The text below goes a little more in depth, first some definitions, then some theory. When you have noted the maximum sizes in X and Y direction, change the firmware and re-flash the printer board.Something similar can be done for the Y-axis.When the carriage is about to hit the frame, note the value, this is your bed X size (for a CoreXY make sure the carriage is clear over the whole Y-axis). Now flash the firmware and home the X-axis, jog the carriage in increments to the right and observe the position on the LCD or through a connected application over USB.Second, define the bed dimensions temporarily to be the design size (do note to not bluntly jog the carriage to the end positions!).See How to center my prints on the build platform? (Re-calibrate homing offset) to set these margins correctly as you effectively need to reposition the print area on the build area. If there was enough space for the carriage, and a value for X_MIN_POS defined, this value needs to be decreased.
0 Comments
Leave a Reply. |